SP108E LED Wi-Fi Controller

The SP108E LED Wi-Fi Controller is only used with a Digital flex strip. This Wi-Fi controller works on a 2.4G Wi-Fi network. It will not operate on a 5G WIFI network. The Free APP is LED SHOP and is available for both iOS 10 and Android 4.4 or later. This controller supports many IC protocols.  They include WS2811, WS2812B, WS2801, SK6812, SK6812-RGBW, WS2813, SK9822, APA102, WS2818, LPD6803, LPD8806, TM1913, UCS1903, SM16703, DMX512. It will not work on standard RGB or RGBW flex. The SP108E LED Wi-Fi Controller is pre-set with 180 different multi-colour dynamic modes and 8 kinds of single-colour modes. These include meteor, breathing, wave, chasing, stack, flash, flow and static modes. The colour, brightness and speed are all adjustable on the APP. Another nice feature is the image-to-effect function. It can capture the image’s colour and create distinctive colour effects that coordinate the light colour with your room’s atmosphere. There are two ways to connect to this controller. The first is the AP (Access Point) mode. In the AP mode, the controller and phone connect directly, and the controller works as an access point. Connection steps While the device is not connected to any WIFI network, the controller’s power will remain in the “Wait-For-Connect” mode for 20 seconds. Check that your phone is connected to a WIFI network and open LED Shop APP. Press the Add Device button and input the WIFI password. Then press the OK to confirm and wait for the configuration processing to finish; When the controller successfully joins the WIFI network, it will show on the device list. Users can select the controller and remove it from the network by pressing the Remove Device button. When you do this, the controller will switch into AP mode.